how to use aircrack with 2 network cards

All setup commands (now applied to the opposite interface) were executed successfully and again the ap now appeared to be running on 'wst' and status messages were observed in the terminal but still no SSID being advertised. We set up the client connection on 'wap' and the ap on 'wst', placing 'wst' in monitor mode this time. We looked at the available WiFi networks on both a Windows phone and a Samsung mobile phone.Įverything was cleared down and I tried again, but with the interfaces reversed. probe requests) were observed in the terminal, however the SSID was not being published.

The ap seemed to run and status messages (e.g. I then ranĪirbase-ng on the 'wap' interface which created the at0 interface as is usual which I can configure, bring up and capture from. I figured out how to connect to our work WiFi and connected to it as a client using the 'wst' interface. I don't know if I did this correctly, but I used iw to place the 'wap' interface in monitor mode and left 'wst' in managed (station) mode. Other details (not sure how relevant they are): It was recognized in dmesg as – Intel ® Centrino ® Advanced-N 6205 AGN, REV0xB0 As I mentioned I would get back to you with the driver info once I got back to work.

How to use aircrack with 2 network cards